How to Upload Image and Add Panels / Inverters / Storage

How to Upload Image and Add Panels / Inverters / Storage

You can upload an image by following these steps:

  1. Navigate to the Design Tool
  2. Click on the "Gear" Icon on the down right hand side of design page.
  3. Toggle to the "Change" option.
  4. A dialogue box will then pop up , select "Upload Image"
     & press confirm.
  5. Another dialogue will pop up asking to confirm if you want to change map , select "Yes" 
  6. Upload the required image.

Once the image is uploaded ,you will see the "Panel Array " tab activated, follow the below steps to Add Panels.
1. Navigate to the Panel Array on the right side of the screen & select the desired Panel make / Edit the number of Panels / Array tilt / Azimuth.
2. You can then create array groups , change azimuth , change the tilt etc if required.

To add Inverters , follow below steps:
1.Deselect Panel Array.
2.Select "Inverter"
3.Navigate to the Inverter details on the right hand side.
4.Select the desired make / capacity / number of inverters / Inverter groups.

To add Storage (battery) , follow below steps:
1. Deselect  Inverter.
2.Select "Storage"
3.Navigate to the Storage details on the right hand side.
4.Select the desired make / capacity / number of battries / reserve percentage.
5.You can also toggle off the Self Consumption to upload "Time based discharge" 






Here is a reference video: